PIC-PG3 - PARALLEL PORT PIC 8/18/28/40 PIN DEVICES PROGRAMMER

FEATURES:

• PIC-PG3 is programmer based on D.Tait's parallel port design. To operate it needs external power supply 12-15VAC or 16-18VDC. It supports all 8/18/28 and 40 pin PIC microcontrollers which allow serial programming. PIC-PG3 have connector and cable for ICSP programming and can be used to program all PIC-PxxB prototype boards.
• The supported devices depend on the current version of ICPROG software.
• Dimensions 75x58 mm (3x2.3") + 30 cm (12") ICSP cable

DOCUMENTS:

• PIC-PG3 tutorial by SparkFun
• NOTE: The programmer may not work with low power serial interfaces - i.e. laptop or notebook serial ports. USB to serial cables have also not been proven to work.

HARDWARE:

• PIC-PG3 schematic
• PIC ICSP connector

• ICPROG from Bonny Gijzen is the best software for serial ports programmers we ever know. And it's FREE!
• PICALLW - SHAREWARE software by Bojan Dobaj
• FREE software by Nigel Goodwin