1693 Adafruit 2030 Adafruit NewCondition
PowerBoost 1000 Basic - 5V USB Boost @ 1000mA from 1.8V+ assembled view

PowerBoost 1000 Basic - 5V USB Boost @ 1000mA from 1.8V+

14.84

Product Code : 1693

In Stock Now : 3
Incl. Tax: £14.84 Excl. Tax: £12.37
  • PowerBoost 1000 Basic - 5V USB Boost @ 1000mA from 1.8V+ with coin
  • PowerBoost 1000 Basic - 5V USB Boost @ 1000mA from 1.8V+ components view
  • PowerBoost 1000 Basic - 5V USB Boost @ 1000mA from 1.8V+ diagonal view
  • PowerBoost 1000 Basic - 5V USB Boost @ 1000mA from 1.8V+ with phone charging
  • PowerBoost 1000 Basic - 5V USB Boost @ 1000mA from 1.8V+ assembled view

PowerBoost 1000 Basic is the perfect power supply for your power-hungry portable project. This little DC/DC boost converter module can run from 1.8V batteries or higher, and convert that voltage to 5.2V DC for running your 5V projects. With a beefy 4A DC/DC converter, it can give you 1A+ from as low as 2V.

Like the 5V 1A USB wall adapter, the output has been tweaked to be 5.2V instead of a straight-up 5.0V so that there's a little bit of 'headroom' long cables, high draw, the addition of a diode on the output if you wish. The 5.2V is safe for all 5V-powered electronics like Arduino, Raspberry Pi, or Beagle Bone while preventing icky brown-outs during high current draw because of USB cable resistance.

The PowerBoost 1000 Basic has at the heart a TPS61030 boost converter from TI. This boost converter chip has some really nice extras such as low battery detection, 4A internal switch, synchronous conversion, excellent efficiency, and 700KHz high-frequency operation.

  • Synchronous operation means you can disconnect the output completely by connecting the ENable pin to ground. This will completely turn off the output
  • 4A internal switch means you can get 1000mA+ from as low as 1.8V, 1500mA+ from 2 NiMH or Alkaline batteries, and at least 2000mA from a 3.7V LiPoly/LiIon battery or 3 NiMH/Alkalines. Just make sure your batteries can actually supply the required 2-4A
  • Low battery indicator LED lights up red when the voltage dips below 3.2V, optimized for the most common usage of LiPo/LiIon battery usage
  • On-board 1000mA charge-rate 'Apple/iOS' data resistors. Solder in the included USB connector and you can plug in any iPhone or iPod for a speedy 1000mA charge rate. Works with iPads, both mini and 'classic' type.
  • Full breakout for battery in, control pins and power out
  • 90%+ operating efficiency in most cases (see datasheet for efficiency graphs), and low quiescent current: 5mA when enabled and power LED is on, 20uA when disabled (power and low battery LED are off)

Great for powering your robot, Arduino project, single-board-computer such as Raspberry Pi or BeagleBone! Each order comes with one fully assembled and tested PCB, a loose 2-PH JST jack, a 2-pin Terminal block and a loose USB A jack.

If you are powering your project from USB, solder the USB A jack in (a 3-minute soldering task). Then choose either JST for input (JST is often used for our LiIon batteries, but the connector is only rated for 2A) or a terminal block.

The 1000 version comes with a 2-pin terminal block so you can solder it to the output spot where the USB jack would go. Or don't solder any connectors in for a more compact power pack and go with 22AWG wires soldered directly in.

  • Dimensions: 29mm x 23mm x 2mm / 1.1" x .9" x .1"
  • Height: w/ JST: 7.5mm / .30"
  • Weight: 6.0g

You may also be interested in the following product(s)

USB LiPoly Charger - Single Cell

USB LiPoly Charger - Single Cell

Incl. Tax: £12.77 Excl. Tax: £10.64 As low as: £11.50
Lithium Ion Polymer Battery - 850mAh

Lithium Ion Polymer Battery - 850mAh

Incl. Tax: £7.09 Excl. Tax: £5.91 As low as: £5.68
PowerBoost 500 Charger - Rechargeable 5V Lipo USB Boost @ 500mA+

PowerBoost 500 Charger - Rechargeable 5V Lipo USB Boost @ 500mA+

Incl. Tax: £14.89 Excl. Tax: £12.41
Lithium Polymer Battery - 2000mAh

Lithium Polymer Battery - 2000mAh

Incl. Tax: £13.19 Excl. Tax: £10.99 As low as: £9.24

Write Your Own Review

Only registered users can write reviews. Please, log in or register