1468 SparkFun BOB-11420 SparkFun NewCondition
MiniGen - Pro Mini Signal Generator Shield

MiniGen - Pro Mini Signal Generator Shield

25.52

Product Code : 1468

In Stock Now : 1
Available in 5-7 days : 24 units.
Impuestos Incluídos: 28,58 € Impuestos no Incluídos: 23,82 €
  • MiniGen - Pro Mini Signal Generator Shield

This is the MiniGen Signal Generator, a small shield for the Arduino Pro Mini that is capable of generating sine, square, or triangle waves at up to 3MHz, and approximately 1Vp-p. Though the MiniGen is technically a shield it can, in fact, operate as a stand-alone board capable of the the same functionality as it would if it were placed on top of a Pro Mini.

The MiniGen offers two out put sources for you to utilize: a 2-pin 0.1" spaced header and a u.FL connector. The output is at a DC offset of Vcc/2, however neither the offset nor the amplitude can be varied. By default, the MiniGen ships configured with a 3.3V regulator enabled and should only be used with 3.3V signals (or 3.3V Pro Minis if you are using this as a shield) unless the jumper on the back is soldered over to bypass the regulator for 5V use.

  • 10-bit DAC for good accuracy
  • 2 frequency registers
  • 2 phase registers
  • SPI Interface Driven at 40MHz
  • Operating Voltage: 3.3V (5V when jumper is soldered)

Te podría(n) interesar también el/los siguiente(s) producto(s)

Arduino Pro Mini 328 5V/16Mhz

Arduino Pro Mini 328 5V/16Mhz

Impuestos Incluídos: 10,33 € Impuestos no Incluídos: 8,60 € Valor mínimo: 8,25 €
u.FL to SMA connector lead

u.FL to SMA connector lead

Impuestos Incluídos: 3,96 € Impuestos no Incluídos: 3,30 €
Header Row (Pin/Male)

Header Row (Pin/Male)

Impuestos Incluídos: 2,42 € Impuestos no Incluídos: 2,02 € Valor mínimo: 1,69 €
Arduino Pro Mini 328 3.3V/8Mhz

Arduino Pro Mini 328 3.3V/8Mhz

Impuestos Incluídos: 10,33 € Impuestos no Incluídos: 8,60 € Valor mínimo: 8,28 €

Escribir Tu Propia Revisión

Sólo usuarios registrados pueden escribir sus opiniones. Conéctese o regístrese