1738 SparkFun SEN-13322 SparkFun NewCondition
Soil Moisture Sensor in use

Soil Moisture Sensor

4.26

Product Code : 1738

In Stock Now : 14
Available in 5-7 days : 188 units.
TTC : 4,77 € HT : 3,98 €
  • Soil Moisture Sensor bottom view
  • Soil Moisture Sensor diagonal view
  • Soil Moisture Sensor view with measurements
  • Soil Moisture Sensor in use
  • Soil Moisture Sensor front view

The Soil Moisture Sensor is a simple breakout for measuring the moisture in soil and similar materials. The soil moisture sensor is pretty straight forward to use. The two large exposed pads function as probes for the sensor, together acting as a variable resistor. The more water that is in the soil means the better the conductivity between the pads will be and will result in a lower resistance, and a higher SIG out.

To get the Soil Moisture Sensor functioning all you will need is to connect the VCC and GND pins to your Arduino-based device (or compatible development board) and you will receive a SIG out which will depend on the amount of water in the soil. One commonly known issue with soil moisture sensors is their short lifespan when exposed to a moist environment. To combat this, we’ve had the PCB coated in Gold Finishing (ENIG or Electroless Nickel Immersion Gold). We recommend either a simple 3-pin screw pin terminal or a 3-pin jumper wire assembly (both can be found in the Recommended Products section below) to be soldered onto the sensor for easy wiring.

Vous pourriez également être intéressé par le(s) produit(s) suivant(s)

Arduino Uno - R3

Arduino Uno - R3

TTC : 29,57 € HT : 24,64 € Prix spécial : 23,65 €
Atmospheric Monitoring with Arduino

Atmospheric Monitoring with Arduino

TTC : 5,59 € HT : 5,59 €
   

Rédigez votre propre commentaire

Seuls les utilisateurs inscrits peuvent écrire des commentaires. Veuillez vous connecter ou vous enregistrer