1468 SparkFun BOB-11420 SparkFun NewCondition
MiniGen - Pro Mini Signal Generator Shield

MiniGen - Pro Mini Signal Generator Shield

25.52

Product Code : 1468

In Stock Soon

Available in 5-7 days : 15 units.
Notify me when this product is in stock:
Incl. Tax: $32.67 Excl. Tax: $27.23
  • MiniGen - Pro Mini Signal Generator Shield

This is the MiniGen Signal Generator, a small shield for the Arduino Pro Mini that is capable of generating sine, square, or triangle waves at up to 3MHz, and approximately 1Vp-p. Though the MiniGen is technically a shield it can, in fact, operate as a stand-alone board capable of the the same functionality as it would if it were placed on top of a Pro Mini.

The MiniGen offers two out put sources for you to utilize: a 2-pin 0.1" spaced header and a u.FL connector. The output is at a DC offset of Vcc/2, however neither the offset nor the amplitude can be varied. By default, the MiniGen ships configured with a 3.3V regulator enabled and should only be used with 3.3V signals (or 3.3V Pro Minis if you are using this as a shield) unless the jumper on the back is soldered over to bypass the regulator for 5V use.

  • 10-bit DAC for good accuracy
  • 2 frequency registers
  • 2 phase registers
  • SPI Interface Driven at 40MHz
  • Operating Voltage: 3.3V (5V when jumper is soldered)

You may also be interested in the following product(s)

u.FL to SMA connector lead

u.FL to SMA connector lead

Incl. Tax: $4.53 Excl. Tax: $3.78
Header Row (Pin/Male)

Header Row (Pin/Male)

Incl. Tax: $2.76 Excl. Tax: $2.30 As low as: $1.93
Shield Header Kit

Shield Header Kit

Excl. Tax: $3.19 Incl. Tax: $3.83
Arduino Pro Mini 328 3.3V/8Mhz

Arduino Pro Mini 328 3.3V/8Mhz

Incl. Tax: $11.80 Excl. Tax: $9.83 As low as: $9.46

Write Your Own Review

Only registered users can write reviews. Please, log in or register